Connecting A Monitoring Cable To A Ws332M2-5 Ambient Temperature And Humidity Sensor; Connecting Cables To The Region-Type Water Sensor; Connecting Cables To The Location-Type Water Sensor - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Step 3 Connect one end of the RJ45 network cable to the AI/DI port on the ECC500 collector.
----End
4.3.4.5 Connecting a Monitoring Cable to a WS332M2-5 Ambient
Temperature and Humidity Sensor
Prerequisites
A monitoring cable is prepared.
Procedure
Step 1 Connect one end of the network cable to the wiring port on the T/H sensor.
Step 2 Connect the other end of the network cable to the COM4/12V or COM5/12V port on the
ECC500 collector.
----End

4.3.4.6 Connecting Cables to the Region-type Water Sensor

Prerequisites
A monitoring cable is prepared.
Procedure
Step 1 Connect one end of the network cable to the Ethernet port on the water detector.
Step 2 Connect the other end of the network cable to the AI/DI port on the ECC500 collector.
----End

4.3.4.7 Connecting Cables to the Location-type Water Sensor

Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of the network cable to the RJ45 port on the tie line.
Step 2 collector.Connect the other end of the network cable to the COM4/12V or COM5/12V port on
the ECC500 collector.
----End
Issue 03 (2019-03-10)
A maximum of eight T/H sensors can connect to each port.
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
89