Formatting An Access Controller - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Table 6-35 Parameter description
Parameter
Name
IP Address
Port
After an Access Controller is created, its information is displayed in the list, as shown in
Figure
Figure 6-77 Checking the access controller information
After the access controller is added, format it manually in the access controller list to avoid
failure in initializing the access controller.
----End

6.4.3.4 Formatting an Access Controller

This topic describes how to format access control cards, historical records, timezones, and
holidays.
Prerequisites


Issue 03 (2019-03-10)
Description
Device name
Set this parameter to the IP address of the collector to which the
device is connected.
Set this parameter to the port through which the device connects to
the collector.
To learn ports on the ECC collector, see Setting RS485 Parameters
for the ECC500 V6 Collector.
6-77.
You have logged in to the NetEco client by web browser
You have the operation rights for Access Control Management.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
224