Installing An In-Room Single-Door Magnetic Lock - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Step 7 (Optional) Adjust the magnet.
1.
2.
----End

3.8.3 Installing an In-Room Single-Door Magnetic Lock

Context


Procedure
Step 1 Fold the delivered cutout template along the dotted line by 90° , as shown by (2) in
3-50.
Step 2 Close the door, place the cutout template near the door top in the door opening direction,
mark the mounting holes, and drill holes, as shown in
Figure 3-50 Marking mounting holes
(1) Door frame
Step 3 Remove the hoisting strip using the delivered hex key.
Issue 03 (2019-03-10)
If the magnet cannot attract the door properly after power-on, place a magnetized metal
part near the magnet to check whether the magnet provides a proper magnetic force.
If the magnetic lock and the magnet do not work properly, check and troubleshoot the
circuit.
Check that the room door is a single-door that can be rotated open outwards. The door
frame should be over 42 mm thick. A glass door is not supported.
The cable routes are planned.
Copyright © Huawei Technologies Co., Ltd.
(2) Cutout template
3 Installing Devices
Figure 3-50.
(3) Door panel
Figure
48