Table of Contents
Advertisement
iManager NetEco 6000
Device Installation and Commissioning Guide
Parameter
Device address
Out Time
Connection mode
Authentication
password
Table 6-15 SNMP v1/v2 device parameter description
Parameter
Name
IP Address
Port
Read Community
Write Community
Issue 03 (2019-03-10)
Description
Set this parameter to the address set on the device.
Timeout duration for connection test (set to 3s by default)
Indicates the connection mode of a device. You can set this
parameter to Non-SSL Connection or SSL Connection.
If you modify Connection Mode on the NetEco, you must modify
Connection Mode on the device WebUI at the same time.
NOTE
Connection Mode for the NetEco and device must be the same.
By default, Connection Mode is set to SSL Connection for the NetEco
and device.
Indicates the re-authentication password for the NetEco and device.
1. Click Modify.
NOTE
After the device is saved, the Modify button is displayed.
2. In the displayed dialog box, enter the New Password and
Confirm Password.
NOTE
The default re-authentication password for the NetEco and device is
Modifyme_123.
The device password should be consistent with the NetEco password.
If the password does not meet requirements, modify it on the device.
3. Choose Send To Device.
NOTE
If you click YES, the re-authentication password for the NetEco and device
is changed at the same time. If you click NO, only the re-authentication
password of NetEco is changed on the server.
4. Click OK.
Description
Device name
Set this parameter to the device IP address.
Set this parameter to the port number of the device. (set to 161 by
default)
Set this parameter to the read community set on the device. (set to
public by default)
Modifying community per three months is advised.
Set this parameter to the write community set on the device. (set to
private by default)
Modifying community per three months is advised.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
170
Advertisement
Table of Contents
