Table of Contents
Advertisement
iManager NetEco 6000
Device Installation and Commissioning Guide
Step 6 Secure the magnetic lock, as shown by (2) in
Step 7 Install the magnet.
1.
2.
Figure 3-55 Installing a magnet
(1) Rubber pad
Step 8 (Optional) Adjust the magnet.
Issue 03 (2019-03-10)
Take out the magnet, and knock the positing pins of the magnet into the ma gnet using a
rubber mallet.
Figure 3-54 Installing positioning pins of a magnet
Insert the assembled magnet into the positioning holes in the door, and secure the magnet
to the door using the screws and rubber pad delivered with the magnetic lock, as shown
in
Figure
3-55.
When securing the magnet to the door panel, do not over-tighten the screws so that the rubber pad is
elastic. The rubber pad will adjust the magnet to a correct position because of its elasticity.
Copyright © Huawei Technologies Co., Ltd.
Figure
3-52.
3 Installing Devices
51
Advertisement
Table of Contents
