Creating A Pdu On The Neteco - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Step 4 Set RS485 port parameters for the collector based on the value of BaudRate, DataBit,
StopBit, and Parity of the device. For ECC collector settings, see
Parameters for the ECC500 V6
----End

6.4.6.2 Creating a PDU on the NetEco

Prerequisites



Procedure
Step 1 Choose Configuration > Configuration Management > Data Center Planning from the
main menu. The Data Center Planning window is displayed.
Step 2 Select the management domain to add a device.
Step 3 In the lower-left corner of the page, click the Device tab.
Step 4 Click the drop-down list box in Type and select PDU.
Step 5 Select the device to be added and drag its icon to the management domain.
Step 6 Specify parameters shown in
PDU complying with the MODBUS-RTU protocol is used as an example.
Issue 03 (2019-03-10)
You have logged in to the NetEco client.
You have the operation rights for Data Center Planning.
You have created a management domain for the device to be added on the Data Center
Planning page.
To delete a device, click the device and choose Delete under
Copyright © Huawei Technologies Co., Ltd.
Collector.
Figure 6-82 in the right pane based on the following table. The
6 Adding Devices
6.4.1.4 Setting RS485
.
237