Siemens Sinumerik 840D sl Function Manual page 787

10/15
A30640 (F)
Response
Acknowledgment
Explanation
Remedy
Response for F
Acknowledgment for F IMMEDIATELY (POWER ON)
F30649
Response
Acknowledgment
Explanation
© Siemens AG 2015 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
-- Check that the control cabinet is EMC--compliant and the cable
routing (e.g. connect the motor cable shield and brake conductors
with the shield connecting plate or screw the motor connector to the
enclosure).
-- Replace the Motor Module involved.
Operation with Safe Brake Module or Safe Brake Adapter:
-- Check the connection of the Safe Brake Module or Safe Brake
Adapter.
-- Replace the Safe Brake Module or Safe Brake Adapter.
SI P2: Fault in the shutdown path of the second channel
OFF2
IMMEDIATELY (POWER ON)
The Motor Module has a communication error with the higher--level
control to transfer the safety--relevant information, or there is a commu-
nication error between Motor Modules connected in parallel.
Note:
This fault results in a STOP A that can be acknowledged.
Fault value (r0949, interpret as decimal):
Only for internal Siemens troubleshooting.
For a higher--level control, the following applies:
-- Check the PROFIsafe address in the higher--level control and Motor
Module and if required, correct
-- Save all parameters (p0977 = 1).
-- Carry out a POWER ON for all components.
In general:
-- Upgrade the Motor Module software.
NONE (OFF2)
SI P2: Internal software error
OFF2
IMMEDIATELY (POWER ON)
An internal error in the Safety Integrated software in monitoring channel
2 has occurred.
Note:
This fault results in a STOP A that cannot be acknowledged.
Fault value (r0949, interpret as hexadecimal):
Only for internal Siemens troubleshooting.
10.3Safety messages for SINAMICS S120
Diagnostics
10-787