Siemens Sinumerik 840D sl Function Manual page 719

10/15
27206
Parameter
Explanation
Response
Remedy
Program r
continuation
27207
Parameter
Explanation
Response
Remedy
Program r
continuation
27208
Parameter
Explanation
© Siemens AG 2015 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
PROFIsafe: MD %1[%2] max. number of F net data (%3 bits)
exceeded
%1 MD name
%2 MD field index to the MD name
%3 max. F net data bits
Data parameterized in the specified machine data lie outside the F net
(useful) data area of the F module.
Note
When displaying machine data MD10386/10387 $MN_PROFI-
SAFE_IN/OUT_ADDRESS, the sub--slot address parameterized in the
machine data exceeds the F net data area of the F module.
Mode group not ready
Channel not ready
NC start disable in this channel
Interface signals are set
Alarm display
NC stop for alarm
Correct the specified MD.
Switch control system OFF and ON again.
PROFIsafe: MD %1[%2] max. sub- -slot number: %3 exceeded
%1 MD name
%2 MD field index to the MD name
%3 max. sub--slot address
The sub--slot parameterized in the specified machine data exceeds the
max. permissible number of sub slots per PROFIsafe module.
Mode group not ready
Channel not ready
NC start disable in this channel
Interface signals are set
Alarm display
NC stop for alarm
Reduce the number of sub--slots by changing the F net (useful) data
distribution of the PROFIsafe module.
Switch control system OFF and ON again.
PROFIsafe: MD %1[%2] max. sub- -slot address %3 exceeded
%1 MD name
%2 MD field index to the MD name
%3 max. sub--slot address
An excessively high sub--slot address was entered in the specified MD.
The entered value may not exceed the displayed maximum sub--slot
address.
10.2NCK safety alarms for Sinumerik 840D sl
Diagnostics
10-719