Siemens Sinumerik 840D sl Function Manual page 633

10/15
10.2 NCK safety alarms for Sinumerik 840D sl
Alarms for SINUMERIK 840D sl/SINAMICS S120
Detailed explanations of all alarms that are not described here can be found in the
following references for the SINUMERIK 840D system with SINAMICS S120:
Reference:
Alarms for SINUMERIK Safety Integrated
The alarms that can occur in connection with the SI option are listed below:
14710
Parameter
Explanation
© Siemens AG 2015 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
/DA/ Diagnostics Manual SINUMERIK 840D
/LH1/ SINAMICS S List Manual
Channel %1 Block %2 Error in initialization sequence in function
%3
%1 = channel number
%2 = block number
%3 = identifier
After the control has booted, (program)RESET and (program)START,
depending on machine data MD 20110 $MC_RESET_MODE_MASK
and MD 20112 $MC_START_MODE_MASK initialization blocks are
generated (or not generated as the case may be).
In this case, errors can occur due to incorrect machine data settings.
The errors are output with the same error messages, which are also
issued if the function was incorrectly programmed in the part program.
In order to clearly indicate that an error refers to the initialization
sequence, in addition, this alarm is generated.
Parameter %3 specifies which function initiated the alarm:
Control boot and (program) RESET:
Value:
0: Error when synchronizing, preprocessing/main run
1: Error when selecting the tool length compensation
2: Error when selecting the transformation
3: Error when selecting the work offset
When booting, the macro definitions and cycle interfaces are also
read--in. If an error occurs here, then this is signaled with value=4 or
value=5.
6: Error when creating 2 1/2--D protection zones when booting
(program) START
Value:
100: Error when synchronizing, preprocessing/main run
101: Error when selecting the tool length compensation
102: Error when selecting the transformation
103: Error when selecting the synchronous spindle
104: Error when selecting the work offset
10.2NCK safety alarms for Sinumerik 840D sl
Diagnostics
10-633