Siemens Sinumerik 840D sl Function Manual page 576

Commissioning
9.5 Acceptance test
5) COMPLETING THE REPORT
Documenting and reporting the tested commissioning state
5.1 Check the SI machine data
5.2 Check the hardware configuration of the PROFIsafe I/O
5.3 Check the NCK and SINAMICS software releases
5.4 Log of the checksums (axis MD / SPL / PROFIsafe I/O)
5.5 Completing the NCK commissioning (protect synchronous actions)
5.6 Completion of the PLC commissioning
5.7 Verify the data backup
APPENDIX
S Reports/measurement records for FUNCTION TEST PART 1/2
S Alarm logs/servotrace measurements (only for a conventional acceptance test)
S Archive the following SI--relevant data:
-- NC machine data
-- Drive parameters
-- PLC--/NCK--SPL program
-- PLC project
Note
The template in the toolbox is only a recommendation.
An electronic template for the acceptance report is available:
-- in the toolbox for SINUMERIK 840D sl
-- on DOConCD for SINUMERIK 840D sl
-- on the service CD for SINUMERIK 840D sl
The acceptance report is divided into the following sections:
-- Plant/system description
-- Description of the safety functions
-- Test of safety functions
9-576
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
© Siemens AG 2015 All Rights Reserved
10/15