Siemens Sinumerik 840D sl Function Manual page 427

10/15
37908
MD number
Default value: 0
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
Special cases, errors,...
37909
MD number
Default value: 0
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
Special cases, errors,...
© Siemens AG 2015 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
$MA_SAFE_CAM_RANGE_BIN_OUTPUT_3[0...14]
Output assignment, cam range bit for cam track 3
Min. input limit: 0
Protection level: 7/2
This machine data specifies the outputs for the cam range bits of cam track 3.
Structure: see coding of the output assignment, see Page 8-417
Field index n corresponds to the parameterizable cam range numbers on cam track 3.
The cam range number is defined using the following machine data:
MD36938 $MA_SAFE_CAM_TRACK_ASSIGN[0...29]
Signal means
= 0, axis is not located on the cam with cam range number n
= 1, axis is located on the cam with cam range number n
Example:
The signal that is addressed using field index 5 goes to 1 if the axis is located at the cam
that is assigned to cam track 3 by parameterizing the cam range number 5.
Note:
The "safe cam track" function is enabled using MD36903 $MA_SAFE_CAM_ENABLE.
If the cam range number n is not parameterized on cam track 3 then the signal of field index
n can never go to 1. The output MD with field index n must in this case not be para-
meterized.
$MA_SAFE_CAM_RANGE_BIN_OUTPUT_4[0...14]
Output assignment, cam range bit for cam track 3
Min. input limit: 0
Protection level: 7/2
This machine data specifies the outputs for the cam range bits of cam track 4.
Structure: see coding of the output assignment, see Page 8-417
Field index n corresponds to the parameterizable cam range numbers on cam track 4.
The cam range number is defined using the following machine data:
MD36938 $MA_SAFE_CAM_TRACK_ASSIGN[0...29]
Signal means
= 0, axis is not located on the cam with cam range number n
= 1, axis is located on the cam with cam range number n
Example:
The signal that is addressed using field index 5 goes to 1 if the axis is located at the cam
that is assigned to cam track 4 by parameterizing the cam range number 5.
Note:
The "safe cam track" function is enabled using MD36903 $MA_SAFE_CAM_ENABLE.
If the cam range number n is not parameterized on cam track 4 then the signal of field index
n can never go to 1. The output MD with field index n must in this case not be para-
meterized.
8.1 Machine data for SINUMERIK 840D sl
Max. input limit: 84020620
Max. input limit: 84020620
Data Description
Unit: - -
Unit: - -
8-427