Siemens Sinumerik 840D sl Function Manual page 371

10/15
13305
MD number
Default value 0
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
corresponds with ...
Additional references
13307
MD number
Default value 0
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
corresponds with ...
Additional references
13308
MD number
Default value - -
Change becomes effective after: POWER ON
Data type: STRING
Meaning:
corresponds with ...
Additional references
© Siemens AG 2015 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
$MN_PROFISAFE_IN_SUBS[0...47]
Substitute values for passive connections to PROFIsafe input modules
Min. input limit: 0
Protection level: 7/2
For passive connections to PROFIsafe input modules, substitute values parameterized in
the machine data are transferred to SPL inputs ($A_INSE) parameterized using MD10388
$MN_PROFISAFE_IN_ASSIGN[n].
If the SPL inputs parameterized using MD10388 $MN_PROFISAFE_IN_ASSIGN[n] over-
lap with the SPL inputs of an active slot, then the substitute values of the passive slot are
adapted by the control so that SPL inputs are not allocated twice. The states of the signals
from the active slots have priority.
MD10095 $MN_SAFE_MODE_MASK, bit 1
MD13304 $MN_PROFISAFE_IN_SUBS_ENAB_MASK
$MN_PROFISAFE_IPO_RESERVE
Number of IPO clock cycles without PROFIsafe calculations
Min. input limit: 0
Protection level: 7/2
The value specifies the number of IPO clock cycles per PROFIsafe clock cycles, in which
no PROFIsafe calculations should be made.
This machine data is only active if machine data MD10095 $MN_SAFE_MODE_MASK, bit
3 is set.
The number of IPO clock cycles must be selected lower than the value in machine data
MD10098 $MN_PROFISAFE_IPO_TIME_RATIO.
$MN_PROFISAFE_IN_NAME[0...47]
Name of the PROFIsafe input module
Min. input limit: - -
Protection level: 7/2
Every PROFIsafe input module can be assigned a symbolic name. If a name is assigned,
this is displayed in the alarm text instead of the PROFIsafe address.
8.1 Machine data for SINUMERIK 840D sl
Max. input limit: FFFFFFFFH
Max. input limit: 50
Max. input limit: - -
Data Description
Unit: - -
Unit: - -
Unit: - -
8-371