Changing The System Password; Reloading The System Default Settings - NEC DS1000 Quick Setup Manual

5. Dial
1807:STA:nnn
HUNT DEST?nnn
6. Enter the Voice Mail master number +
system attendant (e.g., 300).
7. Press
Press

Changing the System Password

The default system passwords are:
To change the system password:
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
9905:PASSWORD PROG
PASSWORD LVL?
3. Enter the level (1-3) for the password you want to change +
9905:PASSWORD PROG
NEW PASS?
4. Enter the new password for the level selected (up to 8 digits) +
9905:PASSWORD PROG
CONFIRM?
5. Reenter the password you entered in step 4 above +
9905:PASSWORD PROG
PASSWORD ACCEPTED
6. Press
Press

Reloading the System Default Settings

To reload the factory-installed default settings (and permanently erase all the site-specific
programming):
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
9999:INITIALIZATION
INITIALIZE SYS?NO
DS1000/2000 Quick Setup Guide
3 (Busy/Ring No Answer Hunting for All Calls) and press
If you don't want to use Voice Mail, the overflow destination can be another extension or the
CONF and go back to step 3 to program another extension.
OR
CONF twice to exit program 1807.
Password Level
System Administrator 1
System Administrator 2
Installer
9905 + HOLD . You see:
CONF to return to step 3 and select another password to change.
OR
CONF twice to exit program 9905.
9999 + HOLD . You see:
Section 1: Start-up Programming
VOL Up
HOLD .
Password
0000
9999
372000
HOLD
HOLD
HOLD . You see:
Section 1: Start-up Programming
. You see:
Level
1
2
3
. You see:
. You see:
1
1-15