Testing The Connection; Checking The System's Serial Port Settings; Programming Smdr - NEC DS1000 Operation Manual

The Update Utility and SMDR

Testing the Connection

To test the connection:
1. Open HyperTerminal on your Windows PC or laptop:
- Click Start + Programs + Accessories + Communications + Hyperterminal.
- Double-click Hyperterm.exe.
- Name your connection, pick an icon, and click OK.
2. When you see the Connect To screen, open the Connect using drop down and select Direct to Com n
(where n is the number of the PC COM port connected to the system).
3. Click OK after making your selection above.
4. When you see the COMn Properties, set the parameters to the following:
- Bits per second = 19200
- Data bits = 8
- Parity = none
- Stop bits = 1
- Flow control = none
5. Click OK after making your selections above.
6. Press Enter.
7. From the PC or laptop keyboard, press Shift 1 to enable history.
8. Once you have verified that everything is working OK, press Shift 1 again to disable history.

Checking the System's Serial Port Settings

To check the system's serial port settings:
1. Enter the programming mode.
2. Enter 0301 + HOLD.
3. Press VOL
4. Enter the new baud rate, if required + HOLD.
(0=1200, 1=2400, 2=4800, 3=9600, 4=19200, 5=38400)
5. Press CONF to exit program 0301.
Go to Programming SMDR below.
Note: You can press Ctrl + Break on the PC connected to the system serial port to toggle through the avail-
able system baud rates.

Programming SMDR

For additional SMDR programming options, see Station Message Detail Recording in the Software Manual
on your System Document CD.
● 0301: SMDR Port
Enter 1 to enable SMDR output from the system's RS-232-C port.
●
0301: Print SMDR Header
Enter Y to have the beginning of the SMDR report include the column header data. Enter N to have the
SMDR report only include the call data (without the header).
● 1001: Print SMDR
Enter Y to have the SMDR report include calls on the trunk. Enter N to have the SMDR report exclude
calls on the trunk.
5-2 ◆ Section 5: Maintenance Options and SMDR
You should see some diagnostic data. If you press Enter again, you will see:>
If you don' t see anything (or garbage) on your screen, check your connections and HyperTer-
minal settings and try again.
To verify the connection, lift the handset or use features at any telephone. History data will dis-
play on the PC or laptop screen.
▲ until you see: BAUD?nnnn
OR
DS1000 Hardware Manual