•
System will require a reboot before it will use any changes made to any 10-12 program.
•
When the VOIP DB is installed you should use the VOIP DB in place of the CPU Interface Card. You
should never have both connected at the same time.
•
It is a good practice to program 0.0.0.0 into Program 10-12-01 when using the VOIP DB connection to
avoid any potential future IP conflicts.
Other Important Ethernet Program address:
Default Gateway:
DHCP Client Setting:
DNS Primary Address:
DNS Secondary Address:
Confirming a system's IP address:
1)
From any display phone press: Menu
2) Dial 96, then press select
3) System IP Address should show the CPU's IP address set in 10-12-01, VOIP DB will show the VOIP IP address
set in program 10-12-09. If this shows an address different than you have loaded check program 10-63-01 DHCP
Client Setting.
Default Line Settings:
Trunk Type:
Caller ID:
Trunk Group Assignment
Incoming Call Type:
Incoming Ring Group:
Default Station Settings:
Incoming Ring Group:
Feature Keys:
Class of Service
Toll Restriction
Trunk Group Routing
Default Summary:
•
Lines 1-12 appear on all phones.
•
Lines 1-12 Ring to Incoming Ring Group 1, Incoming Ring Group 1 will ring Extensions 101-108 by default.
•
All extensions are not Toll Restricted and may make an out bound call by pressing a line key or by dial 9 which
will access Trunk Group 1 which all lines are assigned too by default.
InMail:
Below Version 2 InMail disabled by default, Version 2 systems InMail is detected Automatically upon Cold Start,
Version 3 and higher InMail is detected when installed, once system is powered up
Refer to the SL1100 Features & Specification Guide under "InMail-Auto Setting" SL1100 InMail Guide
Quick Setup section for InMail installation details.
Program 10-12-03 Default: 0.0.0.0.
Program 10-63-01 Default: Enabled, this should be disabled if you wish to
manually assign your system's IP address.
Program 90-11-11 Default: 0.0.0.0 (Needed for InMail E-mail Notification)
Program 90-11-12 Default: 0.0.0.0
Loop Start
Disabled
Trunk Group 1
Normal
IRG 1
Ext. 101 – 108 assigned to IRG 1
Keys 1-12 are Lines 1 -12
Ext. 101 = COS 15, all others 1
Unrestricted
Class 2
Trunk Group 1
- 7 -
Program 14-02-10
Program 14-05
Program 22-02
Program 22-05
Program 22-04
Program 15-07
Program 20-06
Program 21-04
Programs 14-06, 21-03