Error
Error
code
Packing material
[1890] E40
not removed.
Time-out for the
[2700] ---
scanner device.
(MG4100 series,
MG4200 series
only)
Premium
[4100] E12
Contents print
error.
*1:
MG2100 series, MG2200 series, MG3100 series, and MG3200 series only
*2:
MG4100 series and MG4200 series only
1-2. Service Call Error (by Cyclic Blinking of Alarm and Power LEDs)
Cycles
of LED
Error
blinking
2 times Carriage error
U
Message on the
*1
No.*2
LCD*2
---
Remove the
protective material
or tape if it is
attached to the
holder.
---
Timeout error has
occurred. Select
[OK].
---
Cannot print the
data.
Error
*1
code
[5100] P02 (1) Foreign material that obstructs the carriage
movement:
-> Remove foreign material.
(2) Smearing, scratches, or dislocation of the timing
slit strip film:
-> Clean and re-attach the film.
If the film is damaged, replace it.
(3) Carriage flexible cable condition (wrong or
imperfect connection, connection at an angle,
damage, etc.):
-> Re-connect the cable.
If the cable is damaged, replace the carriage
unit.
(4) Carriage motor harness condition (wrong or
imperfect connection, connection at an angle,
damage, etc.):
-> Re-connect the cable.
If the cable is damaged, replace the carriage
motor. Note that the carriage motor is not
designated as a service part.
(5) If the error still occurs:
-> Replace the part(s) listed on the right (under
"Parts to be replaced if the listed solutions are
not effective").
Solution
- Open the paper output cover,
remove the tapes and packing
material from the carriage, then
close the paper output cover.
- The buffer became full in the middle
of scanning operation, and 60
minutes have elapsed since then,
making re-scanning unstable. Press
the OK button to clear the error.
- Non-genuine ink cartridge are
installed. Install the supported
(Canon-genuine) ink cartridges.
Check points & Solution
(6/34)
easyfixs.blogspot.com
Parts that are likely
to be faulty
- Carriage unit
Parts to be replaced if
the listed solutions
are not effective
- Carriage unit
- Logic board ass'y