Reference Parameters/Normalizations - Siemens Sinamics S110 Function Manual

Hide thumbs Also See for Sinamics S110:

Table of Contents

Reference parameters/normalizations

Reference values equivalent to 100% are required in order to express units in percentage

terms. These reference values are entered in parameters p2000 to p2007. They are

computed during the calculation via p0340 = 1 or in STARTER during drive configuration.

After calculation in the drive, these parameters are automatically protected via p0573 = 1

against overwriting through a new calculation (p0340). This eliminates the need to adjust the

references values in a PROFIdrive controller whenever a new calculation of the reference

parameters via p0340 takes place.

If a referenced form is selected and the reference parameters (e.g. p2000) are changed

retrospectively, the referenced values of some of the control parameters are also adjusted to

ensure that the control behavior is unaffected.

Using STARTER offline

Following offline drive configuration, the reference parameters are preset; they can be

changed and protected under Drive → Configuration → "Disabled list" tab.

If the reference values (p2000 to p2007) are changed offline in STARTER, it can lead to

boundary violations of the parameter values, which cause fault messages during loading to

Function Manual

Function Manual, 01/2011, 6SL3097-4AB10-0BP3

Illustration of conversion with reference values

Drive functions

7.2 Basic functions

Show Quick Links

Table of Contents