Table; Network 1: Configure Parameters Menu (9902) - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

Table 5-14

Network 1: Configure Parameters Menu (9902)

Parameter ID
Velocity Units 9080
Demand Scalar 9912
Aux Demand Scalar 9913
Network Timeout 9934
IP Address 9960
Subnet Mask 9961
Gateway Address 9962

Table 5-15

Network 1: Register Data from Drive Menu (9400)
Parameter
Data From Drive 01
Data From Drive 02
Data From Drive 03 to 64

Table 5-16

Network 1: Register Data to Drive Menu (9600)
Parameter
Data To Drive Reg 01
Data To Drive Reg 02
Data To Drive Reg 03 to 64
NXGPro+ Communication Manual
Function Manual, AA, A5E50226719
Unit Default Min
%
1 -125
1 -125
0 0
172.16.20
.18
255.255.0
.0
172.17.1.
1
ID Unit Default
9401 General Sta‐
tus
9402 Motor Speed
9403 to None
9464
ID Unit Default
9601 Fixed Reg
Bits
9602 Velocity De‐
mand
9603 to None
9664
Modbus Ethernet Communication
5.4 Parameter Assignment/Addressing
Max Description
Designate the units for velocity values from the drive:
• %
• RPM
• Hz
125 Set the scalar for input demand reference from the
network.
125 Set the auxiliary scalar for input demand reference
from the network.
65535 Set the timeout for network determined to be non-re‐
sponsive.
Set the system TCP-IP address.
Set the system TCP-IP subnet mask.
Set the system TCP-IP gateway address.
Min Max Description
Register data from drive parameter 1.
Register is not programmable.
Register data from drive parameter 2.
Register is not programmable.
Register data from drive parameters 3 to 64.
Registers are programmable.
Min Max Description
Register data to drive parameter 1.
Register is not programmable.
Register data to drive parameter 2.
Register is not programmable.
Register data to drive parameters 3 to 64.
Registers are programmable.
65