Siemens Sinamics S110 Function Manual page 688

Basic information about the drive system
10.8 Licensing
System response where license is insufficient for a function module
An insufficient function module license is indicated via the following fault and LED on the
Control Unit:
● F13010 Function module license, not licensed
● The OFF1 response brings the drive to a standstill.
● RDY LED permanently lit
Properties of the license key
● Is assigned to a specific memory card.
● Saved in non-volatile memory.
● Is not transferrable.
● Can be acquired using the "WEB License Manager" from a license database.
Generating a license key via the "WEB License Manager"
The following information is required:
● Serial number for the memory card
● License number and delivery note number of the license (on the Certificate of License)
1. Call up the "WEB License Manager".
2. Choose "Direct access".
3. Enter the license number and delivery note number of the license.
4. Enter serial number.
5. Select a product, e. g. "SINAMICS S CU3xx".
6. Choose "Available license numbers".
7. Check the assignment.
8. When you are sure that the license has been correctly assigned, click "OK".
9. The license key is displayed and can be entered.
686
NOTICE
The drive system cannot be operated if the license for a function module is insufficient.
The drive requires a sufficient license in order for it to operate normally.
http://www.siemens.com/automation/license
→ Click "Next".
→ Click "Next".
→ Click "Next".
→ Click "Assign".
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
Function Manual