SSANGYONG Y200 Manual page 1593

Defroster Calibration
On the blower AUTO step, when the passenger sets
to Defroster (Def), the system increases the blower
voltage by 2 V for some intervals comparing AUTO
voltage. But it is excluded the condition when the
blower voltage is above 11.0 V. Also, the voltage
increasing by defroster calibration is limited up to 10.5 V.
Vehicle Speed Calibration
On the Ambient or the 1/3 Ambient and the blower
AUTO, the blower decreases the voltage with the
vehicle speed 100 Km/h such as 1.5 V for the Ambient,
1.0 V for the 1/3 Ambient.
But it is the exception for the blower max.
Ambient Temperature Display
It indicates the ambient temperature as 0.5 ° C
increment in the set temperature digit by ambient
temperature sensor.
•
When you push the AMB key it indicates the ambient
temperature for 5 seconds and return back the set
temperature.
•
If you push the AMB key again during indicating in
5 seconds, it returns back.
•
The ambient temperature sensor is securing in the
front of radiator and may be influenced easily to
the heat of the engine compartment in parking.
Therefore the ambient temperature sensor indicates
the ambient temperature accurately on the condition
of above 40 km/h running.
Delivery Condition
For the initial installation (the initial current draw), the
initial mode follows;
Suction
Actuator Mode
Air
Condi- FOOT/
FRESH
tion DEF
SSANGYONG Y200
AUTOMATIC CONTROL HVAC SYSTEM 7D-7
YAD7D050
A/C Blower Mix
Td Basic
OFF OFF
Control
Vent inlet Control
Manual Control
When you push the I/A control switch, you can control
the I/A door manually and the I/A door changes
between the recirculation air and the fresh air flow
alternately by the control switch. For changing the fresh
air step (FRE) to the recirculation air step (REC), the
blower voltage decrease 15% and for changing the
recirculation air step (REC) to the fresh air step (FRE),
the blower voltage return back.
AUTO Control
Control by the Vehicle Speed
The system controls the vent inlet according to the
vehicle speed in order to prevent the exhaust gas of
the preceding vehicle from flowing inside with the
vehicle stopping or driving at low speed. The operation
and control condition is following as;
1. When the vent inlet mode is AUTO and the A/C
"ON".
2. When the vehicle keeps to drive at below 10 km/h
for 10 seconds and changes the REC mode at stop.
3. If 10 minutes passes after changing the REC mode,
it returns back to the AUTO mode.
YAD7D060
YAD7D070