SSANGYONG Y200 Manual page 1838

9D-82 BODY ELECTRICAL
2. operation of alarm
•
After the situation of robbery vigilance is set on,
not released the situation of robbery vigilance,
with all the door, tail gate and hood are closing,
after this situation are going on more than one
second, if door, tail gate and hood is opened,
alarm should be operating immediately.
•
If only one thing among alarm conditions is
satisfied, immediately the operation should begin
to start, siren is operating continuously for 27
seconds, after siren,condition of alarming is again
satisfied, once again siren is operating
continuously for 27 seconds.
•
Under the state of vigilance, if only tail gate is
opened by key, the state of vigilance should be
set on the regular state of vigilance into secondary
state of vigilance.(At this time, proceed alarming
as open up tail gate, hood, assist and rear door )
In other words, while not being releasing condition
of vigilance, although switch of tail gate is turned
on, alarming is not operating, state of closing tail
YAD9D2Y0 gate is going on more than one seconds, again
back to regular state of vigilance, with siren once,
tail lamp is "ON/OFF" two times for 0.5 seconds.
Under the operation of alarming, if battery is
removed, and then if the battery is installed, state
of memory which is previously removed gets
back, this state will be operating.
3. set vigilance of robbery free
•
In case switch of driver key cylinder is unlocked
or rekes is unlocked, IGN1 OR IGN2 is turned,
under the those condition only, should be set
vigilance of robbery free.(while alarming of
robbery is turned on, turn IGN1, IGN2 ON, relay
of start inhibitor is "OFF", alarming of robbery
is continuously operating for remaining times )
•
Setting vigilance of robbery free is released by
key of driver seat, key of tail gate, unlock of
rekes and lock.
YAD9D2Z0
YAD9D3A0
SSANGYONG Y200