SSANGYONG Y200 Manual page 1262

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-167
18. To remove the park rod lever: Remove the circlip
from the inner end of the pivot shaft and tap the
outer end of the shaft until it moves free from the
case, then using a wide shallow tapered drift as a
wedge, drive the pin out from the inside of the
case and remove the lever and spring.
Notice: Do not remove the park rod lever unless
absolutely necessary.
KAA5A640
Forward Clutch Cylinder
Tools Required
0555-336259 Clutch Spring Compressor
1. Place the assembly in a horizontal position.
KAA5A650
2. Remove the No. 4 needle bearing (2) and adjust-
ment shims (1) from the input shaft.
3. Remove the circlip from the front of the clutch cylin-
der and remove the input shaft.
4. Remove the overdrive shaft and the C1 clutch hub
assembly from the clutch cylinder.
5. Remove the C1 clutch plates from the cylinder.
KAA5A660
6. Remove the circlip retaining the C3 clutch hub in
the rear of the clutch cylinder and remove the hub.
7. Remove the C2/C4 clutch hub assembly and
remove the No. 5 needle bearing from the C4 hub.
8. Removethe C2 clutch plates.
KAA5A670