Table of Contents
Advertisement
5A-106 AUTOMATIC TRANSMISSION
Step
Using a Digital Volt Meter (DVM), measure the
resistance between S1 terminal A and B.
6
Is the resistance within the specified value?
Replace the S1.
7
Is the action complete?
1. Disconnect the TCM connector B.
2. Check the wiring harness from 10-way transmission
8
connector terminal 1 to TCM terminal B3 for an open
or short to positive and repair as necessary.
Is a repair necessary?
Check for a poor connection at the 10-way transmission
connector and TCM connector and repair the
9
malfunctioning terminals as necessary.
Is a repair necessary?
1. Turn the ignition OFF.
2. Replace the TCM.
10
Is the action complete?
1. Using the scan tool, clear the DTCs.
2. Road test the vehicle within the conditions for
setting this DTC as specified in the text.
11
Does the scan tool indicate that this diagnostic has
run and passed?
Check if any DTCs are set.
Are there any DTCs displayed or previously recorded
12
at Step 2 that have not been diagnosed?
DTC P1733 Solenoid 1 Circuit Open (Cont'd)
Action
Value(s)
Yes
Go to
"Diagnostic
22 - 30 Ω
Aids"
-
Go to Step 11
-
Go to Step 11
-
Go to Step 11
-
Go to Step 11
-
Go to Step 12
Go to
applicable
-
DTC table
No
Go to Step 7
-
Go to Step 9
Go to Step 10
-
Go to Step 2
System OK,
Check
Complete
SSANGYONG Y200
Advertisement
Chapters
Table of Contents
