SSANGYONG Y200 Manual page 1959

42. Remove the flywheel and the crankshaft strainer.
Installation Notice
Tightening torque
43. Unscrew the bolts and remove the crankshaft bearing
caps.
Installation Notice
Tightening torque
Notice
• Remove the bearing cap bolts from inside to outside
with a pair.
• Do not mix up the crankshaft bearing caps and
shells.
Note
• Install in the reverse order of removal.
• Tighten the fasteners with the specified tightening torques.
• Replace the gaskets and bearings with new ones.
• Make sure to install the gaskets in correct direction.
ENGINE ASSEMBLY
DI ENG SM - 2004.4
45 ± 5.0 Nm,
90° + 10°
55 ± 5.0 Nm,
90° + 10°
DI01-61
Y220_01140
Y220_01141
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN