SSANGYONG Y200 Manual page 1267

5A-172 AUTOMATIC TRANSMISSION
7. Lift the separator plate and gaskets from the upper
valve body.
8. Remove the five nylon check balls exposed in the
valve body.
9. Remove the retaining plate, plug, spring and re-
verse lockout valve.
KAA5A840
10. Remove the filter (1) and the large nylon check
ball (2) from the lower valve body.
11. Remove the retaining plates and pins from the 1-
2, 2-3, 3-4, BAR and CAR valves. The pins can
be removed with a magnet.
Notice: Once the pins are removed, the plates are
loose in the valve body and will drop out when the
valve body is turned over.
12. Remove the 1-2, 2-3 and 3-4 shift valves.
KAA5A85A
13. Depress the 4-3 sequence valve plug and remove
the retaining plate.
Notice: The plug is preloaded by the spring and
may unexpectedly fall out of the valve body.
14. Remove the plug, spring and valve
KAA5A860
15. Depress the solenoid 5 valve. Remove the
retaining in and remove the valve, damper guide
and spring.
Notice: The valve is preloaded by the spring and
may unexpectedly fall out of the valve body.
16. Depress the line pressure release valve, remove
the retaining pin, disc (if fitted), spring and valve.
17. Drive out the retaining pin and remove the spring
and ball check valve adjacent to the BAR valve.
KAA5A870
SSANGYONG Y200