SSANGYONG Y200 Manual page 1546

6E-12 STEERING COLUMN
3. Tighten the floor bolt of steering column as
specified torque.
Installation Notice
Tightening Torque
4. Tighten the upper bolt of steering column shaft
as specified torque.
Installation Notice
Tightening Torque
YAD6E220
5. Connect each wiring connector of steering column.
YAD6E230
6. Install the combination switch assembly in
steering column shaft.
YAD6E240
7. Install the contact coil in steering column shaft
which the combination switch is installed.
Notice: When you adjust the neutral position of
contact coil, rotate the contact coil to C.W.
direction until it stops and then again rotate it by
2.9 ±0.2 to C.C.W. direction. Align the mark (
Which is marked in contact coil.
YAD6E250
20 - 25 N•m
(15 - 18 lb-ft)
20 - 25 N•m
(15 - 18 lb-ft)
)
SSANGYONG Y200