SSANGYONG Y200 Manual page 1507

43a
SSANGYONG Y200
TRANSFER CASE - TOD 5D2-85
37. Slide the spring spacer on the camshaft and
position it beneath the drive tang.
38. Place the torsion spring on the camshaft. Position
the first spring tang to the left of the camshaft drive
tang.
YAD5D690
39. Rotate the second spring tang clockwise past the
drive tang.
YAD5D700
40. Push the torsion spring and sleeve in as far as it
will go.
41. Install the helical cam and slide the drive tang
between the torsion spring tangs as far as it will
go.
YAD5D710
42. Install the pin on the tang end of the helical cam
into the hole in the front case. Position the torsion
spring tangs so that they are pointing toward the
top side of the transfer case and just touching the
high-low shift fork.
Notice: Do not bend the helical cam during
installation to the front case because of possible
damage to the pin at the tang end of the motor
shaft.
43. Install the shift rail through the high-low shift fork
and make sure that the reverse gear shift rail is
seated in the front case bore.
YAD5D720