SSANGYONG Y200 Manual page 1278

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-183
21. Holding the cylinder horizontal, install the sleeve
and clutch plate assembly into the cylinder, with
the crest of one wave of the washer in line with
one of the holes in the outside of the cylinder,
until the sleeve contacts the C2 wave washer.
22. Check the C4 clutch pack clearance using 0555-
336260 clutch pack clearance kit.
KAA5A0J0
Notice: With the C2 wave spring compressed, and
the clutch Pack supporting a 2 kg weight, the
dimension from the underside of the C2 pressure plate
to the selective steel is to be between 1.4 - 1.8 mm. If
the clutch is to be gauged from the top of the pressure
plate, then the dimension is to be the actual thickness
of the pressure plate plus 1.4 - 1.8 mm.
23. Use selective plates to achieve the correct
specification. If new friction plates are being
fitted, remove the clutch pack and soak the friction
plates in ATF for a minimum of 5 minutes prior to
reassembly.
Notice: The clutch pack clearance must be taken
KAA5A0K0
before the elements are soaked in ATF.
24. Reassemble the sleeve and clutch pack into the
cylinder. Observe the alignment of the wave
washer to the hole in the cylinder.
25. Install the C2 clutch plates in the cylinder in the
following sequence:
•
Friction disc
•
Steel plate
•
Friction disc
•
Steel plate
•
Steel plate (0574-000013, `014, `015, `016, `019,
`022), or Friction disc (0574-000012 & `017)
•
Steel plate (selective)
KAA5A0L0
•
Friction disc
•
Steel plate (selective)
•
Friction disc