Compressor Oil Replacement - SSANGYONG Y200 Manual

SSANGYONG Y200
COMPRESSOR OIL
REPLACEMENT
Before Oil Replacement
When any part is replaced or there are a lot of gas
leaks in the A/C system, you should add the specified
amount of the oil to keep the approval oil capacity
because the oil for lubricating the compressor
circulates through the A/C system during operating
the compressor.
Total Oil Capacity
Handling Oil
•
Be careful that moistures, dusts etc. must not flow
into the oil.
•
Do not mix with any other material.
•
If the oil leaves outside for long time, it's possible
to mix it with the moistures and so keep the oil
sealed with a container.
Circulating Oil
For checking or adjusting the oil level, set the control
unit to full cold and max blower speed with keeping
the engine run at idle for 20 - 30 minutes in order to
circulate the oil through the compressor.
Replacement Oil
1. Perform the oil circulation and stop the engine.
Remove the compressor on the vehicle.
2. Drain the oil at the position of the system line
connection.
Notice: It may be difficult to discharge the oil when
the compressor is cold. At this time warm the
compressor (40 - 50 ° C) before discharging the
oil.
YAD7B250
GENERAL HVAC SYSTEM 7B-17
265 cc