SSANGYONG Y200 Manual page 1971

DI02-10
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Exhaust
Intake
Y220_02024
Y220_02025
Y220_02026
Y220_02027
• Exhaust: #1, #3, #6
• Intake: #7, #9, #12
Tightening torque
Notice
Check the finger follower positions and align if
needed.
5. Install the intake and exhaust camshaft sprockets and
the timing chain.
Tightening torque
Notice
• If the sprocket bolt is stretched over 0.9 mm, replace
it with new one.
• Always install the intake camshaft sprocket first.
• Ensure that the markings on camshaft sprocket and
timing chain are aligned.
• Make sure that the timing chain is securely seated
on the guide rail.
6. Rotate the crankshaft pulley two revolutions and ensure
that the OT mark on the crankshaft pulley and the OT
mark on the camshaft pulley are aligned.
Notice
If the markings are not aligned, reinstall the cylinder
head.
7. Place the bearing cap with the OT marks on both
camshafts facing upward.
Notice
• Apply the sealant on the cap (#12) for the vacuum
pump when installing.
• Apply the oil on the bearing journals before
installation.
25 Nm
25 Nm + 90°
ENGINE HOUSING
DI ENG SM - 2004.4