SSANGYONG Y200 Manual page 1279

5A-184 AUTOMATIC TRANSMISSION
26. Check the clutch pack clearance using only the
weight from 0555-336260 clutch pack clearance
kit.
Notice: With the clutch pack supporting a 2
kgweight, the dimension from the C3 clutch hub
locating step to the friction plate is to be between
0.80 - 1.05 mm.
27. Use selective plates to achieve the correct
specifica-tion. If new friction plates are being fitted,
remove the clutch pack and soak the friction
plates in ATF for a minimum of 5 minutes prior to
reassembly.
KAA5A0M0 Notice: The clutch pack clearance must be taken
before the elements are soaked in ATF.
28. Lubricate and fit the 3-4 OWC and end caps to
the C2 hub.
29. Align the tangs and fit the nylon thrust washer
onto the C4 hub.
30. Align and fit the C4 hub to the C2 clutch and the
OWC assembly.
31. Check the rotation of the C2 hub. While holding
the C4 hub, the C2 hub should rotate in the
clockwise direction and lockup in the anti-
clockwise direction when viewed from the C2 hub.
KAA5A0N0
32. Apply petroleum jelly to the No. 5 needle bearing
and fit it to the C4 hub.
33. Remove the C2 clutch plates from the clutch cylin-
der.
34. Fit the thrust plate over the cylinder inner hub.
35. Engage the C2/C4 clutch hub assembly in the C4
clutch plates.
36. Install the C2 clutch plates.
37. Install the C3 hub and secure it with the circlip,
ensuring that the circlip is firmly seated in its
groove.
KAA5A0O0
SSANGYONG Y200