SSANGYONG Y200 Manual page 1152

DTC P0706 Transmission Range Sensor Circuit Range/Performance
Step
Perform a Transmission Control Module (TCM)
Diagnostic System Check.
1
Is the check performed?
1. Install the scan tool.
2. Turn the ignition ON, with the engine OFF.
3. Record and then clear DTCs.
2
4. Operate the vehicle within the conditions for
setting this DTC as specified in the text.
Does the scan tool display P0706?
1. Select Gear Lever Position on scan tool Data List.
2. Move the gear shift control lever through all of the
gear ranges (P, R, N, D, 3, 2, 1).
3
Does the scan tool display the correct gear lever
positions?
1. Inspect the TR sensor for damage to its rotating
part or its mountings.
4
2. Inspect the shaft driving the TR sensor for damage.
Is a repair necessary?
Replace the TR sensor or driving shaft as appropriate.
5
Is the acting complete?
Check for damage to the z-link within the transmission
6
and repair as necessary.
Is a repair necessary?
1. Using the scan tool, clear the DTCs.
2. Road test the vehicle within the conditions for
setting this DTC as specified in the text.
7
Does the scan tool indicate that this diagnostic has
run and passed?
Check if any DTCs are set.
Are there any DTCs displayed or previously recorded
8
at Step 2 that have not been diagnosed?
SSANGYONG Y200
Action
AUTOMATIC TRANSMISSION 5A-57
Value(s) Yes
- Go to Step 2
- Go to Step 3
- Go to Step 6
- Go to Step 5
- Go to Step 7
- Go to Step 7
- Go to Step 8
Go to
applicable
- DTC table
No
Go to "TCM
Diagnostic
System Check"
Go to
"Diagnostic
Aids"
Go to Step 4
Go to Step 6
-
-
Go to Step 2
System OK,
Check
Complete