SSANGYONG Y200 Manual page 1482

5D2-60 TRANSFER CASE - TOD
DIAGNOSTIC TROUBLE CODE (DTC) 1743
Shift System Timeout
Circuit Description
The transfer case control unit (TOD) sends current to
move the shift motor upon the position of the 4H/4L
switch.
Conditions for Setting the DTC
•
Shifting to other drive range is failed within specified
range.
Step
Was the TOD Diagnostic System Check performed?
1
1. Turn the ignition switch to OFF.
2. Connect a scan tool to the data link connector (DLC)
and follow the directions given in the scan tool
2
manual.
3. Turn the ignition switch to ON.
4. Request DTC with scan tool.
Is the DTC 1741 or 1742 also shown?
1. Turn the ignition switch to OFF.
2. Disconnect two connectors of the transfer case control
unit (TOD) and black 7-pin connector under the body.
3. Inspect the terminals for damage or improper connection.
4. Repair any damaged pins or terminals on the wiring
3 harness and TOD.
5. Reconnect the connectors and make sure it is seated
properly.
6. Connect a scan tool to the data link connector (DLC).
7. Turn the ignition ON.
8. Request the DTC with scan tool.
Is the DTC still current?
1. Remove the shift motor.
2. Connect the black 7-pin connector to shift motor.
4
3. Check the motor operation by turning the 4H/4L
switch.
Is the motor run?
Replace the TOD.
5
Is the repair complete?
Repair any problems in transfer case assembly.
6
Is the repair complete?
Action
Diagnostic Aids
•
Check for short to ground circuit.
•
Check for the shift motor.
Test Description
The number(s) below refer to step(s) on the diagnostic
table.
3. This step checks the connector and connection
status.
4. This step checks the shift motor.
Value
- Go to Step 2
-
-
Go to Step 4
-
Go to Step 5
-
-
Yes No
Go to "TOD
Diagnostic
System
Check"
Go to
Applicable
DTC Table Go to Step 3
System OK
Replace shift
motor and Go
to Step 3
System OK Go to Step 6
System OK -
SSANGYONG Y200