SSANGYONG Y200 Manual page 1273

5A-178 AUTOMATIC TRANSMISSION
Planet Carrier Assembly and Centre Support
1. Check the carrier and planet assembly for any
damage or irregularity and ensure that all pinions
rotate freely and that the pinion end float is within
0.10 mm - 0.50 mm.
KAA5A0A0
2. Install the One Way Clutch (OWC) retainer (1) to
the planet carrier with the inner edge pointing down-
wards. Inspect the OWC race and the sprag
assemblies for wear or damage. Replace if
necessary.
3. Install the outer (3) race in the drum. Press the
race to the bottom of the drum and install the
retaining circlip (2). Ensure the circlip is firmly
seated in its groove.
4. Install the OWC (1) into the outer race with the lip
edge uppermost. Lubricate the sprags with auto-
matic transmission fluid.
KAA5A760
5. Check that the plugs are fitted to the centre
support, then assemble the centre support into
the OWC, ensuring that the support will rotate in
an anti-clock-wise direction only.
6. Lubricate the No. 9 needle bearing and washer
with petroleum jelly and fit them to the rear face
of the planet carrier.
KAA5A750
7. Install the planet assembly and the centre support
into the case, and align the centre support
mounting bolt holes.
8. Install the centre support bolts finger tight.
9. Install the circlip retainer ensuring that the circlip
is completely seated in the groove of the case.
10. Remove the centre support bolts and apply Loctite
222 or equivalent to the threads. Install the bolts
and torque to specifications.
Installation Notice
Tightening Torque
KAA5A560
20-27 N•m (15-20 lb-ft)
SSANGYONG Y200