SSANGYONG Y200 Manual page 1292

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-197
16. Install the reverse lockout valve, spring, plug and
retaining plate. Ensure that the valve is correctly
oriented.
KAA5A1V0
17. Position the five nylon ball checks in the upper
valve body.
18. Fit the upper valve body gasket. Install the separa-
tor plate over the upper valve body.
KAA5A840
19. Holding the separator plate to the upper valve
body to prevent the check balls from falling out,
install the upper valve body on the lower valve
body. Install all screws finger tight then tighten
the screws to specification in the prescribed
sequence.
Installation Notice
Tightening Torque
20. Install solenoids 1, 2, 3, 4 and 6. Ensure the
solenoid is firmly secured by the retainer and that
the screw is tightened to specification.
KAA5A830
Installation Notice
Tightening Torque
•
The wiring loom ground wire eyelet terminal is
secured beneath the solenoid 1 retainer.
11-16 N•m (8-12 lb-ft)
8-12 N•m (71-106 lb-in)