Diagnosis - SSANGYONG Y200 Manual

8B-12 RESTRAINTS
Possible Cause
Does the warning lamp
Ignition "ON"
blink at seven times for
Check warning
7 seconds and then turn
lamp on I/P
off?
Does the fault code
display on the scan tool
display?
Is there any open in
fuse?
Is there any short in
fuse?
Is there any short in
wiring?
Is there any open in
wiring?
Does the voltage
indicate 11~14V?
Is there any open or
short in wiring?
Is there any open or
short in wiring?

DIAGNOSIS

Yes System OK
No Connect the scan tool to diagnostic connector (ALDL).
Select the fault code display menu and clear code
menu.
Yes Perform "Diagnostic System Check".
No Check any fuse open.
Yes Replace fuse.
No Disconnect wiring connector.
Check any wiring short between fuse and wiring
connector.
Yes Repair wiring.
No Disconnect SDM wiring connector.
Check wiring short between connector terminal and
SDM connector terminal.
Yes Replace airbag wiring.
No Check any open between ALDL connector No.4, No.5
terminal and ground.
Yes Repair wiring
No Ignition "ON"
Measure voltage at the cigar lighter socket.
Yes Check any open or short between ALDL connector
terminal and wiring connector terminal.
No Repair the wiring of the cigar lighter socket.
Yes Repair wiring
No Check any open or short between SDM connector
terminal and wiring connector terminal.
Yes Replace the airbag wiring.
No Replace the SDM.
Action
SSANGYONG Y200