SSANGYONG Y200 Manual page 1285

5A-190 AUTOMATIC TRANSMISSION
13. Assemble the C1/C2/C4 clutch assembly to the
C3 clutch and sun gear assembly.
14. Install this assembly in the transmission case.
KAA5A1B0
Pump Cover and Converter Support
Notice:
•
Do not wash the nose of solenoids in solvent.
•
Ensure that the correct 'O' ring is fitted for the
application.
•
Be careful not to damage the needle bearings on
the assembly. Avoid any axial impact loads during
assembly.
•
Check the transmission end float. This will help to
detect any missing parts or incorrect assembly.
1. Check the pump body for any damage, chips or
irregularity. Check that the bush is firmly staked
in the drive gear.
2. Install the seal flush with the front face of the
pump body.
3. Lubricate the pump bush, and the drive and driven
gears, with automatic transmission fluid.
KAA5A1C0
4. Install the pump driven gear and the pump drive
gear into the pump body.
5. Using a straight edge and thickness gauge, check
that the clearance between pump face and gears
is 0.04 - 0.018 mm.
6. Lubricate the pump body 'O' ring with automatic
transmission fluid and fit it to the pump body. Put
the pump body to one side.
KAA5A810
SSANGYONG Y200