SSANGYONG Y200 Manual page 1675

9A-8 GENERAL BODY
7. Wait approximately 5 minutes, until drying up
prima.
8. Spread cohisive material on the distance of 75 -
100 mm to leaking section.
9. After spreading cohisive material, using the flat
stick and similar equipment, keep body and
cohisive material uniform in order not to leak water.
10. To make sure to finish repairing leaking water,
inject warm water or, hot water on the section of
leaking water.
11. Install parts removed to repair leaking section.
Notice: After repairing section of leaking water
YAD9A110
completely, using stand for leaking. test, check
the section of leaking water again, if abnormal
pressure is checked, repaired cohesive material
may get out of position itself. So leaking water
test should not check on local section of leaking .
Method to Repair Wind Noise
Method to repair wind noise is similar to method to
repair leaking water.
Wind noise of around door opening weather strip is
not proper installed.
Weather but depends on adjusting door and window.
Method to Repair Body Noise
Due to not properly installed parts of body, body noise
is occurred, in order not to make a noise, proceed the
following description.
•
Install completely relative moving parts under
vehicle's moving.
•
Repair clearance of moving parts under vehicle's
moving.
•
In order not to cause body noise about moving
parts, separate, moving parts, treat soundproof.
•
Uniform surface of friction can prevent harding
state.
SSANGYONG Y200