General Inspection; Oil Pump Pressure - SSANGYONG Y200 Manual

SSANGYONG Y200

GENERAL INSPECTION

YAD6A040
POWER STEERING 6A-7

OIL PUMP PRESSURE

Do the pressure checking followed to check the defect
of power steering pump.
Notice: Before checking, check the power steering oil
level and belt tension. When tightening of removing
the fitting, prepare the oil container because the oil
may drop down.
1. Remove the pressure line fitting of power steering
pump.
2. Install the pressure check gauge between the
power steering pump and power steering oil
pressure line.
3. Put the transmission in neutral position.
4. Pull the lever of parking brake.
5. Open the installed pressure check gauge valve
completely.
6. Start the engine and keep it to the idling.
7. Turn the steering wheel several times until the oil
temperature is up to the normal operating
temperature.
8. Close the pressure check gauge valve completely
and then measure the oil pressure.
Notice: Do not keep the valve closed for more
than 10 seconds to protect the damage of pump.
A
9. Open the gauge valve completely and then
measure the oil pressure.
A
10. If the pressure is within specified value, the pump
is normal. If not, replace the power steering pump.
53 - 58 kgf/cm²
3 - 5 kgf/cm²