SSANGYONG Y200
2. Tighten temporarily fixing bolt.
3. Using operation switch of sunroof, close glass
panel slow. (Check motion of glass, up and down,
forwards and backwards freely).
YAD9C3L0
4. Pulling the glass panel, adjust the height of glass
and body.
5. After hight of front glass put the same of height of
body and glass seal and 1 mm height to the rear
is higher than height of body, and then tighten
the bolt.
Tightening Torque
6. Using switch of sunroof, check operation.
YAD9C3M0
7. Turn on the switch, up the glass.
8. Insert side cover (left/right).
Notice: Check the state of installation between
side inner cover and side outer cover.
YAD9C3N0
SUN SHADE
Removal
1. Remove glass panel.
YAD9C3P0
BODY EXTERIOR 9C-57
5 N•m (26 lb-ft)