SSANGYONG Y200 Manual page 1160

DTC P0710 Transmission Fluid Temperature Sensor Circuit Malfunction
Step
Perform a Transmission Control Module (TCM)
Diagnostic System Check.
1
Is the check performed?
1. Install the scan tool.
2. Turn the ignition ON, with the engine OFF.
3. Record and then clear DTCs.
2
4. Select T/M Fluid Temperature on scan tool Data List.
Is the TFT sensor value less than specified value?
Is the TFT sensor value greater than specified value?
3
1. Turn the ignition OFF.
2. Disconnect the 10-way transmission connector
4
(additional DTCs will set).
3. Turn the ignition ON.
Is the TFT sensor value greater than the specified value?
1. Turn the ignition OFF.
2. Disconnect the TCM connector B.
3. Turn the ignition ON.
5
4. With a test light connected to B+, probe the TFT
sensor signal circuit, terminal 9 at the 10-way
transmission connector.
Does the test light illuminate?
Replace the TFT sensor.
6
Is the action complete?
1. Turn the ignition OFF.
2. Disconnect the 10-way transmission connector
(additional DTCs will set).
3. Turn the ignition ON.
7
4. Jumper the TFT ground circuit terminal 10 to the
TFT sensor signal circuit terminal 9 at the 10-way
transmission connector.
Is the TFT sensor value less than specified value?
Repair the short to ground in the TFT sensor signal
8
circuit as necessary.
Is the repair complete?
With a test light connected to B+, probe the TFT
sensor ground circuit at terminal 10 at the 10-way
9
transmission connector.
Does the test light illuminate?
1. Turn the ignition OFF.
2. Disconnect the TCM connector B.
3. Turn the ignition ON.
10
4. Check the TFT sensor signal circuit, terminal 9 at
the 10-way transmission connector for an open or
short to voltage.
Is a problem found?
SSANGYONG Y200
Action
AUTOMATIC TRANSMISSION 5A-65
Value(s) Yes
- Go to Step 2
0.21 V Go to Step 4
4.88 V Go to Step 7
4.88 V Go to Step 6
Go to Step 8
-
- Go to Step 16
0.21 V Go to Step 6
-
Go to Step 16
-
Go to Step 10
- Go to Step 13
No
Go to "TCM
Diagnostic
System Check"
Go to Step 3
Go to
"Diagnostic
Aids"
Go to Step 5
Go to Step 14
-
Go to Step 9
-
Go to Step 11
Go to Step 14