SSANGYONG Y200 Manual page 1233

5A-138 AUTOMATIC TRANSMISSION
Step
1. Disconnect the TCM connector B.
2. With a test light connected to B+, probe the wiring
harness from 10-way transmission connector
8
terminal 2 to TCM terminal B11.
Does the test light illuminate?
Check for a poor connection at the 10-way transmission
connector and TCM connector and repair the
9
malfunctioning terminals as necessary.
Is a repair necessary?
1. Turn the ignition OFF.
2. Replace the TCM.
10
Is the action complete?
1. Using the scan tool, clear the DTCs.
2. Road test the vehicle within the conditions for
setting this DTC as specified in the text.
11
Does the scan tool indicate that this diagnostic has
run and passed?
Check if any DTCs are set.
Are there any DTCs displayed or previously recorded
12
at Step 2 that have not been diagnosed?
DTC P1742 Solenoid 2 Circuit Short (Cont'd)
Action Value(s) Yes
- Go to Step 5
- Go to Step 11
- Go to Step 11
- Go to Step 12
Go to
applicable
- DTC table
No
Go to Step 9
Go to Step 10
-
Go to Step 2
System OK,
Check
Complete
SSANGYONG Y200