Faulty Shift Pattern - SSANGYONG Y200 Manual

Condition
2-3 shift only (no 4th or 1st)
1-4 shift only1-3-4
(Delayed 1-2 shift)
4-3 shift only
1-2-Neutral (1st over run)
1-3 shift only
1-3-4 only
1-2-1 only
No manual 4-3, 3-2 or 2-1
No manual 1st
1st gear only or 2nd,3rd, and 4th
only
1st and 2nd only or 1st, 3rd and
4th only
1st, 2nd and 4th only or 1st, 2nd,
and 3rd (tied up in 3rd)
SSANGYONG Y200

FAULTY SHIFT PATTERN

Possible Causes
•
S1 always OFF.
•
S1 always ON.
•
S2 always OFF.
•
S2 always ON.
•
B1 failed.
•
Loose band adjustment.
•
Front servo piston or seal failed.
•
S1/S2 ball misplaced,
•
Smaller 'O' ring on front servo
piston failed or missing.
•
2-3 shift valve jammed.
•
C1 clutch failed or slipping in 3rd
and 4th. (Gives 1st in 3rd and
2nd in 4th.)
•
Over-run Clutch (OC) /low ball
misplaced.
•
Rear band slipping when hot.
•
Reverse/Low-1st ball misplaced.
•
Rear servo inner 'O' ring
missing.
•
1-2 shift valve jammed.
•
2-3 shift valve jammed.
•
Inhibitor switch fault, 1-2-3 only.
•
3-4 shift valve jammed.
AUTOMATIC TRANSMISSION 5A-43
•
Inspect S1. Repair or replace as
necessary.
•
Check for 12 Volts applied to S1
at all times or for wiring fault.
•
Inspect S1. Repair or replace as
necessary.
•
Check for 12 Volts applied to S1
at all times or for wiring fault.
•
Inspect S2. Repair or replace as
necessary.
•
Check for open circuit or wiring
fault.
•
Inspect S2. Repair or replace as
necessary.
•
Check for open circuit or wiring
fault.
•
Inspect and repair as necessary.
•
Inspect and adjust as necessary.
•
Inspect and repair as necessary.
•
Inspect and replace or refit as
necessary
•
Inspect 'O' ring. Refit or replace
as necessary.
•
Inspect the 2-3 shift valve.
Repair or replace as necessary.
•
Inspect C1 clutch. Repair or
replace as necessary.
•
Inspect ball. Refit or replace as
necessary.
•
Inspect rear band adjustment.
Adjust as necessary.
•
Inspect ball. Refit or replace as
necessary.
•
Inspect 'O' ring. Refit or replace
as necessary.
•
Inspect the 1-2 shift valve.
Repair or replace as necessary.
•
Inspect the 2-3 shift valve.
Repair or replace as necessary.
•
Inspect inhibitor switch. Repair
or replace as necessary.
•
Inspect the 3-4 shift valve.
Repair or replace as necessary.
Action