SSANGYONG Y200 Manual page 1469

Step
1. Repair any damaged pins, terminals, short to battery
circuit.
2. Reconnect the connectors and make sure it is seated
properly.
4
3. Connect a scan tool to the data link connector (DLC).
4. Turn the ignition ON.
5. Request the DTC with scan tool.
Is the DTC still current?
Measure the resistance between terminals of the male
white 7-pin connector.
Is the measurement within specified range?
5
•
Terminal B and terminal C
•
Terminal B and terminal D
•
Terminal C and terminal D
Replace front propeller shaft speed sensor.
6
Is the repair complete?
1. Replace the TOD.
2. Turn the ignition switch to OFF.
3. Connect the scan tool to data link connector (DLC)
and follow the directions given in the scan tool
7
manual.
4. Turn the ignition switch to ON.
5. Delete and request DTC with scan tool.
Is the repair complete?
SSANGYONG Y200
Action
TRANSFER CASE - TOD 5D2-47
Value Yes
- Go to Step 5
5 ~ 6 MΩ
5 ~ 6 MΩ
9 ~ 10 kΩ Go to Step 7
- System OK
- System OK
No
System OK
Go to Step 6
-
-