SSANGYONG Y200 Manual page 1216

•
If diagnosing for a possible intermittent short or
open condition, move or massage the wiring
harness while observing test equipment for a
change.
Test Description
The number(s) below refer to the step number(s) on
the Diagnostic Table.
Step
Perform a Transmission Control Module (TCM) System
Check.
1
Is the check performed?
1. Install the scan tool.
2. Turn the ignition ON, with the engine OFF.
3. Record and then clear DTCs.
2
4. Operate the vehicle within the conditions for
setting this DTC as specified in the text.
Does the scan tool display P1737?
1. Turn the ignition OFF.
2. Disconnect the 10-way transmission connector.
(additional DTCs will set)
3. Connect Solenoid/Thermistor Electrical Tester
(STET) to the 10-way transmission connector of
3
transmission side.
4. Turn the mode knob of STET to 5 and push the red
button.
Does the bulb of open circuit on the solenoids side of
STET illuminate?
1. Remove the valve cover. Refer to the Transmission
in this section.
2. Check the wiring harnesses from 10-way trans
mission connector to Solenoid 5 (S5) on the valve
4
body for an open or short to positive and repair as
necessary.
Is a repair complete?
Using a Digital Volt Meter (DVM), measure the
resistance between S5 terminal A and B.
5
Is the resistance within the specified value?
Replace the S5.
6
Is the action complete?
1. Disconnect the TCM connector B.
2. Check the wiring harness from 10-way transmis-
sion connector terminal 5 to TCM terminal B7 for an
7
open or short to battery and repair as necessary.
Is a repair necessary?
Check the wiring harness from 10-way transmission
connector terminal 8 to TCM terminal B1 for an open
8
and repair as necessary.
Is a repair necessary?
SSANGYONG Y200
DTC P1737 Solenoid 5 Circuit Open
Action
AUTOMATIC TRANSMISSION 5A-121
3. Checks if the S5 circuit in the transmission is mal-
functioning.
4. Check cable in the transmission for open / short.
6. Check resistance between S5 terminal A and B.
Standard value is 3.6 - 5.5 Ω.
9. Check connections of other connectors
Value(s)
-
-
-
-
3.6 - 5.5 Ω
-
-
-
Yes No
Go to "TCM
Diagnostic
Go to Step 2 System Check"
Go to
"Diagnostic
Go to Step 3 Aids"
Go to Step 4 Go to Step 7
Go to Step 11 Go to Step 5
Go to
"Diagnostic
Aids" Go to Step 6
Go to Step 11
Go to Step 11 Go to Step 8
Go to Step 11 Go to Step 9
-