SSANGYONG Y200 Manual page 1261

5A-166 AUTOMATIC TRANSMISSION
5. Using cross shaft pin remover/installer (detent le-
ver) 0555-336258, press the pin from the cross
shaft and withdraw the shaft from the case.
6. Remove the cross shaft pin and spring.
7. Remove the manual valve lever and the park rod.
KAA5A600
8. Depress the tangs and withdraw the 10 pin
connector into the case. Remove the wiring loom
assembly.
KAA5A610
9. Detach the No.7 solenoid wire from the front of
the case.
10. Remove the parking pawl pivot pin and the pawl
and spring from the case.
11. Remove the shaft and the rear servo lever.
KAA5A620
12. Remove the rear servo cover and piston assembly.
13. Remove the B1R circlip, valve and spring.
14. Remove both band adjustment shims.
15. Inspect the output shaft bushing in the case and
replace if necessary.
16. Inspect cooler line fittings and replace as
necessary.
17. Inspect the case for damage.
KAA5A630
SSANGYONG Y200