SSANGYONG Y200 Manual page 1265

5A-170 AUTOMATIC TRANSMISSION
Pump
Notice: The following valves are housed in the pump
cover:
•
Solenoid 7
•
Converter clutch control valve
•
Converter clutch regulator valve
•
Primary regulator valve
1. Remove the wiring loom retainer plate and remove
solenoid 7 with a T30 Torx bit.
2. Remove the five washer head bolts from the cover
plate using a multi-point 8 mm socket.
3. Remove the five Torx head screws from the cover
plate with T30 Torx bit. Note that the long screw
holds the pump body to the pump body cover.
Notice: Do not strike the converter support tube to
loosen the pump body.
KAA5A770
4. Separate the pump body from the pump cover.
5. Remove the cover plate, gasket and seal from the
cover.
KAA5A780
6. Remove the ball check valve and one spring from
the pump cover.
KAA5A790
SSANGYONG Y200