SSANGYONG Y200 Manual page 1264

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-169
4. Mount the clutch assembly on clutch spring com-
pressor 0555-336259 and compress the piston re-
turn spring.
5. Remove the circlip and release the spring.
6. Remove the tool, circlip, keeper and spring.
Notice: Make sure that the spring keeper has not
been caught in the circlip groove, and that all spring
pressure has been released, before removing the tool.
KAA5A730
7. Remove the sealing rings from the C3 clutch
cylinder.
8. To remove the clutch piston from the clutch cylinder,
apply air pressure to the port between the iron
sealing rings on the bearing journals of the cylinder.
9. Remove the reverse sun gear and C3 washer from
the cylinder.
KAA5A740
Planet Carrier Assembly and Centre
Support
1. Remove the No. 9 (2) needle bearing and washer
(1) from the output shaft and the planet carrier.
2. Separate the centre support from the planet carrier
by rotating it anti-clockwise.
KAA5A750
3. Lift the one way clutch (1) from the planet carrier
(5).
4. Remove the circlip (2) retaining the one way clutch
outer race (3) in the planet carrier and remove the
race.
5. Remove the one way clutch retainer (4) from the
planet carrier.
KAA5A760