SSANGYONG Y200 Manual page 1752

SSANGYONG Y200
4. After releasing fixing bolt of motor, remove motor
connector in the relay box, and then separate
motor assembly.
YAD9C3C0
5. Separate power connector in the relay box.
6. After releasing fixing bolt of relay box, separate
relay box from front beam (pushing hook of relay
box of front beam by hand, remove it).
YAD9C3D0
7. Install reverse order of removal.
1) Assemble the closing state in the position of
glass panel
2) Check the position of normal close:
•
NORMAL CLOSE POSITION : After connecting
between relay box and motor, connect the
power and then touch on switch and then the
motor stop.
3) Install the motor.
4) Tighten the fixing bolt of motor.
Tightening Torque
YAD9C3E0
5) Insert hook of relay box into beam of front.
6) Fix relay box with tie wrap.
7) Check operation of sunroof.
YAD9C3F0
BODY EXTERIOR 9C-55
3 N•m (26 lb-ft)