SSANGYONG Y200 Manual page 1410

SSANGYONG Y200
PART TIME - T/C 5D1-31
Cleaning Procedure
Notice: Before cleaning, check the magnet for the
presence of metal particles which indicate internal
chipping of the transfer case.
1. Using cleaning solvent, clean the residual oil and
dirt deposits.
Notice: During cleaning, be careful not to damage
the metal surfaces.
2. After cleaning, dry the parts with low pressure(Max.
20 psi) compressed air.
3. Lubricate the ball bearings and needle bearings
with transfer case oil after cleaning.
Notice: Protect the lubricated bearings from dust.
Inspection Procedure
1. Visually check the all removed parts.
Notice: Always replace the hose coupling, O-ring
and oil seal with new parts.
2. Inspection Terms
•
Burr : Local rise of material forming protruding
sharp edge
•
Chip : An area from which a small fragment has
been broken off or cut
•
Crack : Surface break of line nature indicating
partial or complete separation of material.
•
Excessive wear : Heavy or obvious wear beyond
expectations considering conditions of
operation.
•
Indentation : Displacement of material caused
by localized heavy contact.
•
Galling : Breakdown of metal surface due to
excessive friction between parts. Particles of
the softer material are torn loose and welded to
the harder material.
•
Nick : Local break or notch, usually displacement
of material rather than loss.
•
Scoring : Tear or break in metal surface from
contact under abnormal pressure.